Malé diely mosadzná plochá podložka, hladká, DIN 125, metrická, veľkosť skrutky M3, vnútorný priemer 3,2 mm, vonkajší priemer 7 mm, hrúbka 0,5 mm (balenie 100 ks)

Name: Malé diely mosadzná plochá podložka, hladká, DIN 125, metrická, veľkosť skrutky M3, vnútorný priemer 3,2 mm, vonkajší priemer 7 mm, hrúbka 0,5 mm (balenie 100 ks)
Brand: Small Parts
Price: 27.16 EUR
Availability: InStock

Brand:Small Parts

3.4/5

€
27.16

Spĺňa špecifikácie DIN 125. Hladký povrch je bez povrchovej úpravy. Mosadz poskytuje odolnosť proti korózii a ponúka tepelnú a elektrickú vodivosť. Plochá podložka poskytuje dosadaciu plochu na rozloženie zaťaženia upevňovacieho prvku alebo pôsobí ako rozpera.

Suma

Pridať do košíka Kúpte teraz

EAN:

Kategórie Priemysel a veda, Hřebíky, Skrutky a spojovací materiál, Podložky, Ploché podložky,

Exterior Finish	Brass
Fastener Size	M3
Material	Brass
Outside Diameter	7mm Millimeters
Washer Type	Flat

5 Star

4 Star

3 Star

2 Star

1 Star

Napíšte svoju recenziu

Váš email nebude zverejnený. Všetky povinné polia sú označené^*

Vaše hodnotenie

Scritto da: V T

Shorted and Defective

I only received 93 1/2 out of 100. One was cut in half, one was 1mm thick, some were nipped on the edge or cut through the ring on one side. I needed all true 100 pcs for my project. I will not buy from a seller who shorts the quantity to make you buy more to increase their profits.???? Amazon customer service helped me with this problem.☺

Scritto da: Amazon Customer

Four Stars

A little smaller than I was expecting.

Scritto da: Bob L.

Four Stars

Slow shipping but they work fine

Scritto da: Alex Croy

Five Stars

It's a package of washers! Exactly as described! I deeded these for a very specific purpose.

Scritto da: fiatowner

Five Stars

Exactly as advertised, which is what you really want for these kinds of parts.

Scritto da: Ernest Ray Jones

Five Stars

great

Scritto da: El Capitan Asombroso

Good deal for money, expect to do a little work.

For the price, these are a great value for the money. That said there are some issues: my pack had several miss-struck washers that were unusable, there was clearly no finish tumbling as these have burrs and strike flashing. I bought these to use as carburetor needle shims, but I will need to clean up and tumble them before I install them since the thickness isnt uniform.