Armacost Lighting 840600 60 wattový stmievateľný ovládač pre LED osvetlenie, s odnímateľným AC káblom, biele 60 wattové 12 voltové osvetlenie

Name: Armacost Lighting 840600 60 wattový stmievateľný ovládač pre LED osvetlenie, s odnímateľným AC káblom, biele 60 wattové 12 voltové osvetlenie
Brand: Armacost Lighting
SKU: 0850080006528
Price: 101.42 EUR
Availability: InStock

Brand:Armacost Lighting

3.7/5

€
101.42

Osvetlenie Armacost 60-wattový stmievateľný LED ovládač poskytuje vynikajúci výkon LED stmievania a reguláciu jasu v architektonickej kvalite. Hoci prakticky všetky stmievače budú fungovať s týmto stmievateľným LED ovládačom, Armacost Lighting odporúča univerzálne stmievače Lutron CFL a Leviton illumatech z dôvodu ich nastavenia nízkeho rozsahu stmievania. Poskytuje plynulé, stabilné stmievanie bez blikania s pozvoľným štartom a žiadúcim stmievaním a zoslabovaním do tmy. Keď je stmievač nastavený na plný jas, LED ovládač poskytuje plný jas – nedochádza k strate špičkového svetelného výkonu. Priamy drôt. Vodič má plnú bezpečnostnú ochranu proti vypnutiu v prípade preťaženia osvetlenia, prerušenia okruhu, skratu, prehriatia alebo inej poruchy, automatický reštart po odstránení poruchy ide o výkonovú jednotku triedy 2 z hľadiska bezpečnosti a má triedu II AC vstupy, plne izolované puzdro, nie je potrebný uzemňovací vodič. Vnútorné/vonkajšie, atď. Určené pre použitie v suchých a vlhkých priestoroch. Aby vaše LED osvetlenie fungovalo správne, musí byť napájané 12-voltovým jednosmerným prúdom a musí sa dať stmievať. Tento ovládač funguje dobre so všetkým 12V dc LED páskovým osvetlením. Pre iné typy LED osvetlenia kontaktujte výrobcu, aby ste potvrdili, že osvetlenie je stmievateľné a funguje na 12-voltový jednosmerný prúd.

Suma

Pridať do košíka Kúpte teraz

EAN: 0850080006528

Kategórie Nástroje a domáce potreby, Osvetlenie a stropné ventilátory, Osvetlenie Príslušenstvo, Nízkonapäťové transformátory,

Žiadne minimálne zaťaženie; stmievanie funguje rovnako dobre, či už napájate jedno 3-wattové LED svetlo, alebo 60-wattové páskové osvetlenie, alebo kombináciu oboch. Napájací zdroj triedy 2 má ochranu proti preťaženiu, automatické vypnutie. Pripojte až 100 % menovitého 60-wattového maximálneho zaťaženia – zníženie výkonu nie je potrebné. Kompatibilné s 120 V AC stmievačmi a ovládačmi osvetlenia a nízkonapäťovými DC stmievačmi a ovládačmi. Poskytuje plynulé stmievanie bez blikania v celom rozsahu pre 12-voltové LED osvetlenie, ako sú LED pásy, moduly, svetelné lišty, puky a iné akcentačné LED svetlá.

Batteries Included?	‎No
Batteries Required?	‎No
Brand	Armacost Lighting
Capacity Description	‎60 Watt
Certification	‎UL
Color	‎White
Country of Origin	‎China
Current Rating	5 Amps
Customer Reviews	4.7 4.7 out of 5 stars 787 ratings 4.7 out of 5 stars
Included Components	‎60-Watt power supply
Is Discontinued By Manufacturer	‎No
Item Dimensions LxWxH	7.06 x 2.38 x 1.38 inches
Item model number	‎840600
Item Package Quantity	‎1
Item Weight	‎8 ounces
Manufacturer	‎Armacost Lighting
Material	‎Plastic
Mounting Type	Ceiling Mount
Mounting Type	‎Ceiling Mount
Number Of Pieces	‎1
Part Number	‎840600
Pattern	‎Lighting
Plug Format	‎A- US style
Power Source	AC
Power Source	‎AC
Product Dimensions	‎7.06 x 2.38 x 1.38 inches
Shape	‎Rectangular
Size	‎60 Watt
Special Features	‎Detachable AC Cord
Style	‎12 Volt
Type of Bulb	‎LED
Usage	‎ETL Listed for dry and damp location use
Voltage	‎12 Volts
Warranty Description	‎Limited 3-year warranty. This product is for dry and damp locations.
Wattage	‎60 watts

5 Star

4 Star

3 Star

2 Star

1 Star

Napíšte svoju recenziu

Váš email nebude zverejnený. Všetky povinné polia sú označené^*

Vaše hodnotenie

Scritto da: Thomas H.

Had to replace a unit in the kitchen, and this works perfectly

My under cabinet lights stopped working. Changed the dimmer switches, but it finally was the transformer. All good now.

Scritto da: PVM

Does what it's supposed to

Easy installation. I wired directly to a dimmer switch and it works perfectly.

Scritto da: S.C. Fluhr

Smooth dimming led driver

Quality made, nice and compact, works as advertised

Scritto da: paul

Electrician approved

One of the few LED drivers that can be dimmed in compliance with the NEC for electrical inspection. The cord that came with it can be unscrewed and the driver can be hardwired with 14-2 romex. The connections are circuit board terminal blocks on each end, so they required a jeweler screwdriver. Be sure to hold the blocks when tightening the screws, so the block doesn't torque off the circuit board. The unit does soft start and ramp to full in 1 sec. Other than that, there isn't a 3 sec delay to warm up like cheap switching power supplies have before they instantly pop on at full brightness. That's nice. I had no problem using a z-wave smart dimmer. I used the a Linear aka Nortek aka GoControl model WD500Z5 zwave dimmer and it successfully burned in so far for 1 day. It does get very warm, even pushing only 10 watts. Like a hot McDs coffee cup hot. Not too hot to start papers on fire, but too warm to be comfortable holding. Plan for that when mounting. Also, If you wired several LED homeruns instead of daisy chaining the runs, be sure to plan on wirenuts or a terminal block to connect to the driver- it only has internal room for 1 #12 pair of wires. You have no internal room for other connections. I powered 10 watts of LED under cabinet LED tape. The cables in the pic are 14-2 romex and 16-2 cl2 riser cable. No issues with those gauges.

Scritto da: Snap, Crackle and Pop

A high-quality dimmable, "universal" 120V to 12V DC LED driver power supply

The Armacost Lighting 840600 is a high quality, dimmable power supply for 12V LED fixtures or systems. COMPATIBILITY: This power supply should be compatible with a wide range of 120V dimmers. The installation instructions state the following: "Armacost Dimming LED Drivers are compatible with both forward phase (leading edge, triac, incandescent) and reverse phase (electronic low-voltage, ELV, and trailing edge) AC dimmers ... They are also compatible with low-voltage PWM dimmers and RGB color controllers. "Although virtually all dimmers will work with Armacost Dimmable LED Drivers, Armacost Lighting recommends dimmers that can be programmed or have an adjustment dial to set the low end dimming range." BUILT IN CONNECTORS: The built in connectors work well and quickly. They need to have some of the outer insulation to clamp onto, to keep the stress of any pull on the wire from going to the terminal connection itself. So don't strip too much of the inner or outer insulation. LOW MINIMUM POWER LOAD: The minimum power load is just 5 watts. VOLTAGE: Output is 12V DC. DIMENSIONS: It's somewhat large, at 7-1/16 inches long by 2-3/8 inches wide by 1-3/8 inches high. ENCLOSURES: If you want an enclosure, Armacost makes variations with enclosures for conduit connections. The only real negative is the cost, though of course having a high-performing, high quality power supply makes it a reasonable value. Lower-watt drivers are less expensive than this one. The manufacturer's website has lots more info, including specs and installation instruction. TWO WARNINGS: First, be sure to get a power supply rated with enough watts to cover your needs. Second, be careful to get a power supply with the right input voltage. Armacost makes a line of 12V dimmers and matching power supplies. This product is the universal power supply, to be used with a range of dimmers and 120V.

Scritto da: CAMPFIRESKY

NEW KITCHEN SINK LIGHTING

Very easy to install. I hard wired the power pack and also installed a dimmer switch. Works perfectly with no humming. Great product.

Scritto da: Kindle Customer

Everything I wanted at a reasonable price

Put in a dimmer switch and get the 120 leds per meter. You can crank it up to give all the light you will ever need and yet dim it down to simply add ambience to your kitchen. I installed them in the channel with the diffusers and absolutely love them.

Scritto da: Nick

It actually works with a dimmer!!

Wow an LED driver / power supply that actually dims the LEDs!!! I thought there was something wrong with my LEDs or dimmer as I tried two different PLUSPOE dimmers that did not actually dim anything and also buzzed. This driver actually works, and works well. I am using the 12v/24watt one to drive 8x half moon 12v LED stair lights. I am also using a Leviton 6674 dimmer in the wall. There is no switching noise from this driver, the construction is solid and the dimming is smooth without flicker. Completely worth the higher price than non certified drivers. The only thing that was odd is that it did not come with a power cord. The lack of a power cord was not a big deal as I had one laying around, but I could see it bothering other people. I have a light switch controlling half of a receptacle in low voltage box, so I did need one.